404 Wellsaw Parts

HANDLE COVER (#25)

STATOR 115 VOLT (#8)

Push Rod & Stud  for Model 400 SawPush Rod and Stud  for Model 400 Saw

GROMMET (#48)

TOP CAP COVER PLATE (#5)

BALL BEARING (#13)

Armature 115 Volt (#11)

BRUSH HOLDER (#3)

BOTTOM PLATE COVER (#36)

Blade Support Clamp - #22 (Plate Cover) For 404 Wellsaw See parts diagram & listing for details.

Bushing & Seal Housing (#49)

STUD, THREADED (#29)

Spiral Bevel Gear #62

GEAR SHAFT (#40)

Bushing (#16)

HANDLE STUD, H.D. (#54)

INSERT BUSHING (#30)

Gear Stud Nut (New Style) #50A THIS APPLIES TO THE NEW STYLE BLACK COATED HANDLE UNIT

HEX KEY (#21)

THURST BRG. RACE (#44)

NEEDLE THRUST BEARING (#43)

NEEDLE BEARING (#42)

BALL BEARING (#7)

PINION GEAR (#12)

RUBBER U CLIP (#28)

S Clip - #27 (Bar Clamp)

DEFLECTOR (#4)

PUSH ROD & STUD (#18)

HANDLE KNOB (#52)

For 404 Wellsaw See parts diagram and listing for detailsConnecting Rod and Bearing (#38)For 404 WellsawSee parts diagram and listing for details

OIL SEAL (#14)

BLADE CLAMP (#19)

SNAP RING (#39)

SET SCREW---REG.

SCREW, 10/32 X 5/8 (#53)

CLAMP RING (#47)

SPACER (#34)

BRUSH CAP (#1)

This Model 400 16 in Wellsaw Blade Support works with the Jarvis model 400 Wellsaw. 400 16 in Wellsaw Blade SupportJarvis This Model 400 16 in Wellsaw Blade Support works with the Jarvis model 400 Wellsaw. It must be used with the 16 inch Regular Duty...

CAP NUT (#23)

GASKET SEAL (#35)

SCREW (#24)

Screw (8-32x3/16) - #37 for 404 & 444

ROD STUD (#17)

BRUSH & SPRING ASSEMBLY (#2)

GEAR & BEARING ASSEMBLY

SWITCH & TRIGGER (#31)

SET SCREW, LONG, H.D. (#20)

STRAIN RELIEF (#46)

SEAL (#15)

LOCKNUT (#10)

SCREW & LOCK NUT (#26)

DRIVE STUD (#33)